A buzzer sounds and the warning light comes on and flashes to indicate that the master warning system has detected a malfunction. The master warning light also comes on or flashes in order to indicate that a message is currently being displayed on the multi-information display. (see manual for details) *If equipped.
Subaru instrument panel, guages, and warning lights. Outback, Legacy, Forester, Impreza, WRX STI, BRZ, Crosstrek, Tribeca 2013, 2012, 2011, 2010, 2009, 2008
blink along with the signal. Turning on the hazard warning switch will make all four turn signals and both arrows blink (see page 43). Cruise Control Indicator Light When the cruise control system is on, this indicator light is on (see pages 46 and 47). Fuel Reserve Warning Light If the warning light glows, it means you have about 10.0 (2.6
232-011-017-038D Temperature Switch 120°C (Common Ground) Switch Point 55°C M14x1.5 Learn More
Jul 29, 2018 · No. A: Circuit Protected: 1: 10: Main Power Supply And Ground Circuit, Fuel Injection System Function, Injector, Nissan Anti – Theft System, Power Window, Sunroof, Rear Window Defogger, Automatic Drive Positioner, Headlamp, Headlamp Aiming Control System, Daytime Light System, Combination Switch, Turn Signal and Hazard Warning Lamp, Parking Lamps, License Lamps, Tail Lamps, Front Fog Lamps ...
1999-2001 Yamaha Phazer 500, Phazer 500 Mountain Lite, Phazer 500 Deluxe and Venture 500 two-stroke snowmobiles, mountain light dlx electric start pz500 pz500dx vt500xl. 2003-2006 YAMAHA RX-1 SNOWMOBILE MODELS COVERED:
A complete Td5 instrument pack (binnacle, speedometer, engine water temperature and fuel gauges, clock, and warning light panel. Usually available on eBay or at auto jumbles) Wiring loom for the above (YMG109280. Look on eBay or at auto jumbles)
Connect each of the two circuit wires to the appropriate screw terminal on the thermostat, matching the wiring of the original thermostat. Tighten the screw terminals with a screwdriver, making sure the connections are tight. Set the temperature to the desired setting on the thermostat, using a flat-blade screwdriver.
The hot switch remains open (off) until the engine temp reaches somewhere over 200 degrees. So the they added a test circuit that sends a ground from the ign switch to the hot light while in the "start" (engine cranking over) position. You stated that you grounded each wire and each of the two lights lit.